mirror of
https://source.denx.de/u-boot/u-boot.git
synced 2025-08-31 19:41:32 +02:00
5534fb4f48
The PWM pins on North Bridge on Armada 37xx can be configured into PWM
or GPIO functions. When in PWM function, each pin can also be configured
to drive low on 0 and tri-state on 1 (LED mode).
The current definitions handle this by declaring two pin groups for each
pin:
- group "pwmN" with functions "pwm" and "gpio"
- group "ledN_od" ("od" for open drain) with functions "led" and "gpio"
This is semantically incorrect. The correct definition for each pin
should be one group with three functions: "pwm", "led" and "gpio".
Change the "pwmN" groups to support "led" function.
Remove "ledN_od" groups. This cannot break backwards compatibility with
older device trees: no device tree uses it since there is no PWM driver
for this SOC yet. Also "ledN_od" groups are not even documented.
Signed-off-by: Marek Behún <marek.behun@nic.cz>
Reviewed-by: Stefan Roese <sr@denx.de>
This patch series adds support for ZFS listing and load to u-boot. To Enable zfs ls and load commands, modify the board specific config file with #define CONFIG_CMD_ZFS Steps to test: 1. After applying the patch, zfs specific commands can be seen in the boot loader prompt using UBOOT #help zfsload- load binary file from a ZFS file system zfsls - list files in a directory (default /) 2. To list the files in zfs pool, device or partition, execute zfsls <interface> <dev[:part]> [POOL/@/dir/file] For example: UBOOT #zfsls mmc 0:5 /rpool/@/usr/bin/ 3. To read and load a file from an ZFS formatted partition to RAM, execute zfsload <interface> <dev[:part]> [addr] [filename] [bytes] For example: UBOOT #zfsload mmc 2:2 0x30007fc0 /rpool/@/boot/uImage References : -- ZFS GRUB sources from Solaris GRUB-0.97 -- GRUB Bazaar repository Jorgen Lundman <lundman at lundman.net> 2012.