mirror of
https://source.denx.de/u-boot/u-boot.git
synced 2025-11-01 17:01:21 +01:00
6e31c62a17
add DM/DTS support for the UEC ethernet on QUICC Engine
Block.
Signed-off-by: Heiko Schocher <hs@denx.de>
Patch-cc: Mario Six <mario.six@gdsys.cc>
Patch-cc: Qiang Zhao <qiang.zhao@nxp.com>
Patch-cc: Holger Brunck <holger.brunck@hitachi-powergrids.com>
Patch-cc: Madalin Bucur <madalin.bucur@oss.nxp.com>
Series-changes: 3
- revert:
commit "3374264df97b" ("drivers: net: qe: deselect QE when DM_ETH is enabled")
as now qe works with DM and DM_ETH support.
- fix mailaddress from Holger
Series-changes: 2
- add comments from Qiang Zhao:
- add device node documentation
- I did not drop the dm_qe_uec_phy.c and use drivers/net/fsl_mdio.c
because using drivers/net/fsl_mdio.c leads in none existent
udevice mdio@3320
instead boards with DM ETH support should use now this
driver.
- remove RFC tag
Commit-notes:
- I let the old none DM based implementation in code
so boards should work with old implementation.
This Code should be removed if all boards are converted
to DM/DTS.
- add the DM based qe uec driver under drivers/net/qe
- Therefore copied the files uccf.c uccf.h uec.h from
drivers/qe. So there are a lot of Codingstyle problems
currently. I fix them in next version if this RFC
patch is OK or it needs some changes.
- The dm based driver code is now under drivers/net/qe/dm_qe_uec.c
Used a lot of functions from drivers/qe/uec.c
- seperated the PHY specific code into seperate file
drivers/net/qe/dm_qe_uec_phy.c
END
This patch series adds support for ZFS listing and load to u-boot. To Enable zfs ls and load commands, modify the board specific config file with #define CONFIG_CMD_ZFS Steps to test: 1. After applying the patch, zfs specific commands can be seen in the boot loader prompt using UBOOT #help zfsload- load binary file from a ZFS file system zfsls - list files in a directory (default /) 2. To list the files in zfs pool, device or partition, execute zfsls <interface> <dev[:part]> [POOL/@/dir/file] For example: UBOOT #zfsls mmc 0:5 /rpool/@/usr/bin/ 3. To read and load a file from an ZFS formatted partition to RAM, execute zfsload <interface> <dev[:part]> [addr] [filename] [bytes] For example: UBOOT #zfsload mmc 2:2 0x30007fc0 /rpool/@/boot/uImage References : -- ZFS GRUB sources from Solaris GRUB-0.97 -- GRUB Bazaar repository Jorgen Lundman <lundman at lundman.net> 2012.