The driver currently does:
mtd->dev->parent = cadence->dev;
This works in Linux because `struct mtd_info` embeds a `struct device`,
so `mtd->dev` is always valid and its `.parent` can be set.
In U-Boot, however, `mtd->dev` is only a pointer to a `struct udevice`.
Dereferencing it before assignment is invalid, which breaks the device
hierarchy. As a result, consumers relying on `mtd->dev` (e.g. partition
parser, reset and re-init paths) operate on a dangling pointer. This
leads to failures during warm reset when the NAND device is accessed
again.
Fix by assigning the device pointer directly:
mtd->dev = cadence->dev;
This matches U-Boot’s device model, preserves a valid hierarchy, and
resolves the warm reset issue on Cadence NAND.
Fixes: ebc41cad ("drivers: mtd: nand: Add driver for Cadence Nand")
Signed-off-by: Dinesh Maniyam <dinesh.maniyam@altera.com>
Signed-off-by: Michael Trimarchi <michael@amarulasolutions.com>
Enable nand to use bounce buffer. In bounce buffer,
read/write buf will use cadence->buf which has been allocated
using malloc. This will align the memory and avoid memory to be
allocated in different addresses.
Signed-off-by: Dinesh Maniyam <dinesh.maniyam@intel.com>
Poll for thread complete status to ensure the
descriptor processing is complete. If complete then can ensure
controller already update the descriptor status.
Signed-off-by: Dinesh Maniyam <dinesh.maniyam@intel.com>
Ensure ddr memory is updated with the data from dcache.
This would help to ensure cdma always reading the latest dma descriptor
from ddr memory.
Signed-off-by: Dinesh Maniyam <dinesh.maniyam@intel.com>
Support NAND_CMD_SET_FEATURES & NAND_CMD_GET_FEATURES.
These commands is one of the basic commands of NAND. The parameters get
from these commands will be used to set timing mode
of NAND data interface.
Signed-off-by: Dinesh Maniyam <dinesh.maniyam@intel.com>
Add support for reading param page of NAND device.
These paramaters are unique and used for identification purpose.
Signed-off-by: Dinesh Maniyam <dinesh.maniyam@intel.com>
Add support for readid command in Cadence NAND driver.
The id is unique and used for flash identification.
Signed-off-by: Dinesh Maniyam <dinesh.maniyam@intel.com>
Add support for read status command
in Cadence NAND driver. This status bit is important to check
whether the flash is write-protected.
Signed-off-by: Dinesh Maniyam <dinesh.maniyam@intel.com>
Enable driver for Cadence NAND for the family
device agilex5. This driver is leveraged from the path
/drivers/mtd/nand/raw/cadence-nand-controller.c from the
stable version 6.11.2.
Signed-off-by: Dinesh Maniyam <dinesh.maniyam@intel.com>
