* Move current to 5.7.x
* Update linux-rockchip-current.config
* Move dev patches to current
* copy dev to current
* move dev patches to current
* move rockchip64-current to 5.7.x
* WIP: Adding RockpiE config
Signed-off-by: Igor Pecovnik <igor.pecovnik@gmail.com>
* Mainline u-boot for ROCK Pi E
* Initial ROCK Pi E device tree in kernel
* Fixed supplies for ROCK Pi E device tree
* Adjusted u-boot load address for rockchip64 boards with 256MB eg. ROCK Pi E
* Blacklisted lima on ROCK Pi E
* Fixed ROCK Pi E patch after merge from master
* Removed mode settings from rk805 regulators
* Fixed issues with offloading for gigabit interface of RockPi E
* Adjusted ROCK Pi E board config
* Added dev branch for ROCK Pi E
* Add build targets
Signed-off-by: Igor Pecovnik <igor.pecovnik@gmail.com>
* Exchange legacy to current in ROCK Pi E build targets
Co-authored-by: Piotr Szczepanik <piter75@gmail.com>
NanoPi R2S has the same issue as ROC-RK3328-CC.
With working GPIO, during init the GPIO state s reset.
This causes the sdmmc regulator to shut down, preventing detection.
Removing and replacing the card will allow it to be detected, but that should not be necessary.
Fix this by setting the regulator on at boot.
Signed-off-by: Peter Geis <pgwipeout@gmail.com>
Link: 75aa567803
Signed-off-by: Jayantajit Gogoi <jayanta.gogoi525@gmail.com>
Enable DMC for roc-rk3328-cc (renegade) in current
No stability issues with this enabled, no reason not to merge, enables higher clockrates via manual setting for now.
* Cleaned up OrangePi 4 device tree (with help from @chwe17)
* Reconfigured OrangePi 4's usb-c power input
* Powertree fixes for OrangePi 4
* Removed unnecessary xin32k clock in OrangePi 4's device tree
* Reverted fusb302 change for OrangePi 4
* Removed uart4 in OrangePi 4's device tree
* Synced OrangePi 4's DTS from current to dev
* Synced OrangePi 4's DTS from current to legacy
* Minor fixups for OrangePi 4 DTS in legacy
* Add initial support for FriendlyARM Nanopi R2s
One net port not working yet.
* Enable 2nd network, rename it to lan0, adjust motd to see lan*
* Added rk3328 dmc devfreq driver
* Fixed SD card issues for NanoPi R2s
* Added usb serial gadget console for NanoPi R2s
Co-authored-by: Piotr Szczepanik <piter75@gmail.com>
Adds k5.5 audio pipeline dts entries, adds audio to Renegade, cleans up some dts mess in renegade
- Note: PulseAudio seems to need to toggle a couple times before audio will play. That is not addressed in this patch.
