* Switched rockchip64 curent to kernel 5.8.y
* Enforce CRLF in one of the wifi patches for rockchip64-current
* Removed uneeded wifi patches for rtl8189fs from rockchip64-current
* Add Rockpi 4C
* Update config/boards/rockpi-4c.conf
Co-authored-by: Piotr Szczepanik <piter75@gmail.com>
* Change backward compatibility link to B model
* Various changes - tested for building.
- add Radxa overlays
- update naming with mainline
- add Rockpi-E
* Reverting improvements for rockpi legacy and create a link to new DT only
* Copied ROCK Pi 4 device treesplitting patches to dev which was broken
* Add Rockpi 4c targets
Co-authored-by: Piotr Szczepanik <piter75@gmail.com>
* Add initial Helios64 configuration
Add ethernet udev rules
Added disable auto power on script during shutdown
Configure ALSA to output audio to (DisplayPort) USB type-C
armbian-firstrun: exclude helios64 from generating fixed_mac
Each network interface on Helios64 already assigned to unique MAC
address in factory. Assigning Network Manager with cloned MAC is not
needed.
Signed-off-by: Aditya Prayoga <aditya@kobol.io>
* u-boot: rk3399: Add Helios64
Use rockchip propriettary loader
* kernel: rk3399-legacy: Update r8152 to support 2.5GbE USB RTL8156
Required for Helios64
* kernel: rk3399-legacy: update Rockchip PCIe driver
Port changes by ayufan on rockchip64.
* kernel: rk3399-legacy: Add support for Helios64
Add Helios64 device tree.
Enable missing driver/kernel module.
Auto load lm75 modules
Signed-off-by: Aditya Prayoga <aditya@kobol.io>
* kernel: rk3399-legacy: rework roc-rk3399-pc patch
the patch broken due to additional line added by helios64 on
arch/arm64/boot/dts/rockchip/Makefile
Signed-off-by: Aditya Prayoga <aditya@kobol.io>
* kernel: rk3399-legacy: update Rockchip PCIe driver
Backport bugfix from mainline
refer to
https://patchwork.kernel.org/patch/11561979/
and
https://patchwork.kernel.org/patch/11561977/
Signed-off-by: Aditya Prayoga <aditya@kobol.io>
* kernel: rockchip64-current: Add support for Helios64
Add Helios64 device tree.
Enable missing driver/kernel module.
* config: helios64: use mainline ATF on current branch
and u-boot TPL/SPL instead of Rockchip proprietary loader
* helios64: u-boot v2020.07 update
* Add Helios64 target
* kernel: rk3399-legacy: update Rockchip PCIe driver
Removed unrelated changes from porting ayufan fixes
Signed-off-by: Piotr Szczepanik <piter75@gmail.com>
* helios64: make use of PACKAGE_LIST* variables
Co-authored-by: Piotr Szczepanik <piter75@gmail.com>
* Move current to 5.7.x
* Update linux-rockchip-current.config
* Move dev patches to current
* copy dev to current
* move dev patches to current
* move rockchip64-current to 5.7.x
* WIP: Adding RockpiE config
Signed-off-by: Igor Pecovnik <igor.pecovnik@gmail.com>
* Mainline u-boot for ROCK Pi E
* Initial ROCK Pi E device tree in kernel
* Fixed supplies for ROCK Pi E device tree
* Adjusted u-boot load address for rockchip64 boards with 256MB eg. ROCK Pi E
* Blacklisted lima on ROCK Pi E
* Fixed ROCK Pi E patch after merge from master
* Removed mode settings from rk805 regulators
* Fixed issues with offloading for gigabit interface of RockPi E
* Adjusted ROCK Pi E board config
* Added dev branch for ROCK Pi E
* Add build targets
Signed-off-by: Igor Pecovnik <igor.pecovnik@gmail.com>
* Exchange legacy to current in ROCK Pi E build targets
Co-authored-by: Piotr Szczepanik <piter75@gmail.com>
NanoPi R2S has the same issue as ROC-RK3328-CC.
With working GPIO, during init the GPIO state s reset.
This causes the sdmmc regulator to shut down, preventing detection.
Removing and replacing the card will allow it to be detected, but that should not be necessary.
Fix this by setting the regulator on at boot.
Signed-off-by: Peter Geis <pgwipeout@gmail.com>
Link: 75aa567803
Signed-off-by: Jayantajit Gogoi <jayanta.gogoi525@gmail.com>
Enable DMC for roc-rk3328-cc (renegade) in current
No stability issues with this enabled, no reason not to merge, enables higher clockrates via manual setting for now.
* Cleaned up OrangePi 4 device tree (with help from @chwe17)
* Reconfigured OrangePi 4's usb-c power input
* Powertree fixes for OrangePi 4
* Removed unnecessary xin32k clock in OrangePi 4's device tree
* Reverted fusb302 change for OrangePi 4
* Removed uart4 in OrangePi 4's device tree
* Synced OrangePi 4's DTS from current to dev
* Synced OrangePi 4's DTS from current to legacy
* Minor fixups for OrangePi 4 DTS in legacy
* Add initial support for FriendlyARM Nanopi R2s
One net port not working yet.
* Enable 2nd network, rename it to lan0, adjust motd to see lan*
* Added rk3328 dmc devfreq driver
* Fixed SD card issues for NanoPi R2s
* Added usb serial gadget console for NanoPi R2s
Co-authored-by: Piotr Szczepanik <piter75@gmail.com>
Adds k5.5 audio pipeline dts entries, adds audio to Renegade, cleans up some dts mess in renegade
- Note: PulseAudio seems to need to toggle a couple times before audio will play. That is not addressed in this patch.
